For players

Note Frequency Calculator

Convert between note names and frequencies, with cents deviation and a choice of reference pitch.

Note Frequency Calculator

Equal temperament in one formula

In twelve-tone equal temperament every semitone multiplies frequency by the twelfth root of two, about 1.0595. With A4 as the reference, any note's frequency is 440 × 2^(n ÷ 12), where n is the number of semitones above or below A4. Middle C, C4, is about 261.63 Hz; the lowest note on a standard piano, A0, is 27.5 Hz; the highest, C8, is about 4,186 Hz. An octave always doubles the frequency, which is why A5 is exactly 880 Hz.

A = 440 is a convention

Concert pitch at 440 Hz was adopted as an international standard in 1939 and reaffirmed as ISO 16 in 1975. Before then, reference pitches varied widely by city and era. Many orchestras today tune slightly higher, at 442 or 443 Hz, for a brighter sound, and period-instrument ensembles often use 415 Hz for Baroque repertoire — almost exactly a semitone lower. Claims that 432 Hz is more natural or healing have no scientific support; the calculator supports it simply because some musicians prefer it.

Cents measure small differences

A semitone is divided into 100 cents, so an octave spans 1,200. Cents make tuning differences comparable at any pitch: 1,200 × log₂(f ÷ reference) gives the offset. Trained listeners notice differences of around 5 cents between two sustained tones; in a busy mix, 10 to 20 cents may go unnoticed. The calculator reports how far a frequency sits from the nearest equal-tempered note.

Equal temperament is a compromise

Pure intervals built from simple frequency ratios — 3:2 for a fifth, 5:4 for a major third — do not fit neatly into twelve equal steps. Equal temperament makes every key usable at the cost of slightly impure intervals: its major third is about 14 cents wider than a pure 5:4 third, which is why barbershop singers and string quartets, free to adjust, often tune thirds lower than a piano. Pianos add their own twist, stretching octaves slightly because stiff strings produce overtones a little sharp of perfect multiples.

How to use it

  1. Choose the reference pitch for A4, usually 440 Hz.
  2. Select a note and octave to see its frequency, period and wavelength.
  3. Or enter a frequency to find the nearest note and the offset in cents.
  4. Use cents to compare tuning at any pitch.

From the rehearsal room

Which octave number is middle C?

In scientific pitch notation, used here, middle C is C4 at about 261.63 Hz and octave numbers change at C. Some software and keyboard makers call it C3 or C5, so check which convention your equipment uses.

Should I tune to 432 Hz?

Only if you prefer the sound or need to match other players. There is no evidence that 432 Hz is healthier or more natural. Standard concert pitch is 440 Hz, and most recorded music and fixed-pitch instruments assume it.

How many cents out of tune is noticeable?

For two sustained notes played together, beating becomes audible at a few cents, and trained ears hear 5 cents readily. For single notes in a mix, 10 to 20 cents often passes unnoticed, though it can make chords sound sour.

What is the wavelength shown?

The physical length of one cycle of the sound in air at about 20 °C, where sound travels at 343 metres per second. Low notes have wavelengths of several metres, which is why bass is hard to control in small rooms.

Disclaimer: Tempo, tuning, and harmony results follow standard twelve-tone equal-temperament conventions and are intended for practice and production reference. Keep volume moderate, especially with headphones, as prolonged loud listening can damage hearing. Chord and key detection is a best guess and should be checked by ear.