BPM to Delay Time Calculator
Convert tempo into milliseconds and hertz for every note value, including dotted and triplet.
One formula, many settings
A quarter note at a given tempo lasts 60,000 ÷ BPM milliseconds: 500 ms at 120 BPM, 600 ms at 100. Every other note value follows by simple ratios. Halve it for an eighth note, halve again for a sixteenth. A dotted note is one and a half times the plain value, so a dotted eighth at 120 BPM is 375 ms. A triplet note is two thirds of the plain value, so an eighth-note triplet at 120 BPM is about 167 ms. Frequency in hertz is 1,000 divided by the time in milliseconds, which is how LFO rates and tremolo speeds are set. At 120 BPM a quarter-note LFO cycles at exactly 2 Hz.
Why delay times are set to the beat
A delay whose repeats land on a subdivision of the tempo reinforces the rhythm; one that lands between subdivisions smears it. The dotted-eighth delay is the famous example: with repeats falling three sixteenths after each note, a line of straight eighths becomes a cascading sixteenth-note pattern. Many guitarists set their echo this way, and it is why so many delay pedals have a dotted-eighth tap division.
Quarter- and eighth-note delays are the workhorse settings for vocals, and a short slapback of 80 to 120 ms, often untimed, gives a rockabilly doubling effect. Timed delays should usually sit lower in the mix than you think; if you can clearly hear every repeat, it is often too loud.
Reverb and dynamics can be timed too
Reverb pre-delay — the gap before the reverb starts — is often set to a short note value such as a 1/64 or 1/32, keeping the dry attack clear while tying the space to the groove. Reverb decay can be tuned so the tail dies away before the next strong beat, which keeps a dense mix clean. Compressor release times are sometimes set to a note value too, so that gain recovers in time with the music rather than pumping against it.
How to use it
- Enter the tempo in BPM, or measure it with the tap tempo tool.
- Read the times for whole notes down to thirty-second notes.
- Use the dotted and triplet columns for rhythmic delays.
- Use the hertz values for synced LFOs, tremolo and auto-pan.
From the rehearsal room
What is the delay time for a dotted eighth?
Multiply the quarter-note time by 0.75. At 120 BPM, a quarter note is 500 ms, so a dotted eighth is 375 ms. The table lists it directly for any tempo. Set the feedback so you hear two or three repeats, and play straight eighth notes to get the characteristic cascading rhythm.
Why do my delays sound out of time?
Check that the tempo is right — a half-time or double-time error doubles or halves every value. Also check whether the plug-in expects the time of one repeat or the total feedback time, and whether it is already synced to the host tempo.
How do I convert milliseconds to BPM?
Divide 60,000 by the quarter-note time in milliseconds. A 400 ms quarter note is 150 BPM. If the milliseconds represent a different note value, adjust by the ratio first.
What pre-delay should I use on vocal reverb?
Often a short timed value such as a 1/32 or 1/64 note, typically 20 to 60 ms. It separates the dry vocal from the reverb so consonants stay clear. Longer pre-delay makes the space sound larger but can feel detached.
Disclaimer: Tempo, tuning, and harmony results follow standard twelve-tone equal-temperament conventions and are intended for practice and production reference. Keep volume moderate, especially with headphones, as prolonged loud listening can damage hearing. Chord and key detection is a best guess and should be checked by ear.