Production 3 min read Updated 2026-10-08

Set Delay and Reverb to the Song Tempo

From tap tempo to dotted-eighth delays and timed pre-delay, keeping effects inside the groove.

Time-based effects that match the tempo sound musical; effects that do not blur the rhythm. A delay whose repeats land between the beats makes a tight part sound sloppy, and a reverb tail that spills into the next beat muddies the mix. Setting both to the song's tempo takes one number and one formula. This guide works through a mix at 96 BPM.

Step 1: measure the tempo

If the session has a tempo grid, use it. Otherwise, tap along with the song in the tap tempo tool for at least eight beats. Check whether the reading should be halved or doubled: a hip-hop track tapped on every eighth note reads twice its real tempo. Use the tempo a listener would nod their head to.

Step 2: convert tempo to milliseconds

A quarter note lasts 60,000 ÷ BPM milliseconds. Every other note value follows by ratio: half it for an eighth, multiply by 1.5 for a dotted value, by two thirds for a triplet. The BPM delay calculator produces the full table. At 96 BPM:

  • Quarter note: 625 ms
  • Dotted eighth: about 469 ms
  • Eighth note: about 313 ms
  • Eighth-note triplet: about 208 ms
  • Half note: 1,250 ms

At 120 BPM, the familiar values are 500 ms for a quarter, 375 ms for a dotted eighth and 250 ms for an eighth.

Step 3: choose a note value for the job

  • Quarter and eighth notes support a part without drawing attention; common on vocals.
  • Dotted eighths create a cascading rhythm against straight eighth-note playing, a classic guitar sound.
  • Triplets add a swung, rolling feel.
  • Short slapback of about 80 to 120 ms, often untimed, gives a doubling effect associated with early rock and roll.

Set the feedback so you hear two or three repeats, and filter the delay's high and low frequencies so the repeats sit behind the dry sound.

Step 4: time the reverb

Pre-delay — the gap before the reverb starts — keeps the dry attack of a voice or drum clear. A short note value works well: a 1/64 note at 120 BPM is about 31 ms; at 96 BPM about 39 ms. Then set the reverb's decay so the tail has largely died away before the next strong beat or phrase. At 96 BPM, a decay around a half note, 1.25 seconds, suits a dense arrangement; ballads can take longer tails.

When the tempo changes

Songs recorded without a click often drift, and some change tempo deliberately between sections. A delay set from one tap reading will then sit slightly off in other sections. Either tap each section separately and automate the delay time, or use a host-synced delay that follows the session tempo map. For live performance, many delay pedals have a tap-tempo switch; check its reading against the calculator before the show so you know what the right value looks like.

Step 5: mix lower than you think

Effects are usually most effective when they are felt more than heard. If you can clearly hear every delay repeat and every reverb tail while the full mix plays, they are often too loud. Bring them up until the part sounds spacious, then back a little. Automating the delay level up only on phrase endings keeps busy sections clear.

Checklist

  1. Measure the tempo with tap tempo, checking for half or double time.
  2. Convert to milliseconds for the note values you need.
  3. Choose quarter, eighth, dotted or triplet values to suit the part.
  4. Set feedback for two or three repeats and filter the repeats.
  5. Set reverb pre-delay to a short note value and decay to fit the groove.
  6. Lower effect levels until they are felt more than heard.